Application of an atmospheric gene flow model for assessing environmental risks from transgenic corn crops

Authors

  • Junming Wang Department of Agricultural Sciences, Tennessee State University
  • Xiusheng Yang Department of Natural Resources Management and Engineering, University of Connecticut

DOI:

https://doi.org/10.25165/ijabe.v3i3.218

Keywords:

model, risk management, crops, corn, pollen, gene flow, random walk, outcrossing

Abstract

 

Gene flow data from experiments under limited environmental conditions (e.g. wind speed and direction, atmospheric stability) have only provided limited information for gene flow risk management.  It is necessary to apply models to predict the gene flow under a complete set of possible environmental conditions to inform farmers, seed companies, government agencies, and researchers about the risks and potential prevention and precaution methods.  In this paper, the previous validated gene flow model developed by the authors was used to predict gene flow from genetically modified (GM) corn crops.  The model was used to simulate potential gene flow from GM corn sources of different sizes from one plant area of 0.1 m2 to an area 3.1×106 m2 under normal weather conditions.  In addition, the model was also used to predict the potential gene flow for different source strengths, atmospheric conditions, buffer heights, buffer field sizes, and pollen settling speeds from 10,000 m2 sources.  The model simulations have provided gene flow information for risk management under the above conditions and have shown that the source sizes, source strengths, buffer heights, buffer sizes, atmospheric conditions, and pollen settling speeds had important effects on gene flow.  While the atmospheric conditions and pollen settling speeds cannot be controlled, choosing appropriate buffer heights and sizes will effectively prevent gene flow.  The lost seed control is crucial to limit gene flow because even a GM corn plant can result in a grand total deposition flux of 646,272 grains/m2, an outcrossing ratio of 0.016, and outcrossed seed of 110 kernels/m2 at 0.8 m from the plant in the non-target field under normal atmospheric conditions.

 

Keywords: model, risk management, crops, corn, pollen, gene flow, random walk, outcrossing

 

DOI: 10.3965/j.issn.1934-6344.2010.03.036-042

  

Citation: Junming Wang, Xiusheng Yang.  Application of an atmospheric gene flow model for assessing environmental risks from transgenic corn crops.  Int J Agric & Biol Eng, 2010; 3(3): 36

Author Biographies

Junming Wang, Department of Agricultural Sciences, Tennessee State University

Research Scientist, New Mexico State University

Xiusheng Yang, Department of Natural Resources Management and Engineering, University of Connecticut

Professor, Department of Natural Resources Management and Engineering, University of Connecticut, Storrs, CT 06269-4087, USA. Phone: (860) 486-0135, Fax: (860) 486-5408, Email: xiusheng.yang@uconn.edu

Downloads

Published

2010-06-25

How to Cite

Wang, J., & Yang, X. (2010). Application of an atmospheric gene flow model for assessing environmental risks from transgenic corn crops. International Journal of Agricultural and Biological Engineering, 3(3), 36–42. https://doi.org/10.25165/ijabe.v3i3.218

Issue

Vol. 3 No. 3 (2010): IJABE

Section

Structures and Bio-environmental Engineering

License

IJABE is an international peer reviewed open access journal, adopting Creative Commons Copyright Notices as follows.


Authors who publish with this journal agree to the following terms:


  1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.

  2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.

  3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).