Experimental study on combustion pressure oscillation of soybean bio diesel oil

Ma Peng, Liu Huili, Liu Shengyong

Abstract


Abstract: The principal objectives of this study were to examine in-cylinder combustion pressure oscillation characteristics of soybean biodiesel in time domain and time-frequency domain, and their influences on the control and operational parameters, such as injection timing, exhaust gas recirculation (EGR) ratio, engine load and engine speed. In this study, the combustion pressure oscillation characteristics of biodiesel engine for various injection timing, EGR ratio and engine speed were investigated. The corresponding relation of pressure characteristics in the time domain and frequency domain were obtained. The results showed that the pressure oscillation and peak pressure rise acceleration occurred mainly in the diffusion combustion, and the peak pressure rise rate located in the premixed combustion. The in-cylinder pressure level curve can be divided into three stages. The pressure levels of stage 1, stage 2 and stage 3 represent the peak in-cylinder pressure, the maximum amplitude of pressure rise rate and pressure rise acceleration, respectively. As the injection timing retards, the pressure levels of stage 1 and stage 3 decrease gradually. The pressure level curve of stage 3 with 25º before top dead center (BTDC) is the highest and the oscillation is the most significant. It is worth noting that the location of each stage with various operate conditions is not fixed. At 0.41 MPa indicated mean effective pressure (IMEP), with the increase of EGR rate, the pressure levels of stage 1 and stage 2 decrease gradually. The pressure level curve of stage 3 and the maximum amplitude of pressure rise acceleration with 0% EGR rate are the highest. The oscillation with 0% EGR rate is the most significant at 0.41 MPa IMEP. Compared to 0.41 MPa IMEP, the frequency bands of stage 1 and stage 2 at 1.1 MPa IMEP are relatively low due to the soft combustion in the cylinder. As EGR rate increases, the pressure level of stage 1 decreases, and those of stage 2 and stage 3 increase gradually. The oscillation with 30% EGR rate is the most significant. With the increase of engine speed, the pressure levels of stage 1 and stage 2 decrease, and move to the low frequency. The pressure level in the high frequency domain at 1600 r/min is less than that at 1100 r/min, and the combustion process is smooth.
Keywords: combustion pressure oscillation, soybean biodiesel, injection timing, exhaust gas recirculation, engine speed
DOI: 10.3965/j.ijabe.20160906.1680

Citation: Ma P, Liu H L, Liu S Y. Experimental study on combustion pressure oscillation of soybean bio diesel oil. Int J Agric & Biol Eng, 2016; 9(6): 156-166.

Keywords


combustion pressure oscillation, soybean biodiesel, injection timing, exhaust gas recirculation, engine speed

Full Text:

PDF

References


Wang J X, Yang L, Xiao W Y, Liang F, Tan W C, Miao X J, et al. Influence of injection parameters on the performance of a DI diesel engine with GD-1 fuel injection system. Chinese Internal Combustion Engine Engineering, 2004; 25(2): 28–31. (in Chinese with English abstract)

Tan X G, Sang H L, Tao Q. The impact of common rail system's control parameters on the performance of high-power diesel. Energy Procedia, 2012; 16: 2067–2072.

Herfatmanesh M R, Lu P, Attar M A, Zhao H. Experimental investigation into the effects of two-stage injection on fuel injection quantity, combustion and emissions in a high-speed optical common rail diesel engine. Fuel, 2013; 109(7): 137–147.

Agarwal A K, Dhar A, Srivastava D K, Maurya R K, Singh A P. Effect of fuel injection pressure on diesel particulate size and number distribution in a CRDI single cylinder research engine. Fuel, 2013; 107(9): 84–89.

Ye P, Boehman A L. An investigation of the impact of injection strategy and biodiesel on engine NOx and particulate matter emissions with a common-rail turbocharged DI diesel engine. Fuel, 2012; 97(7): 476–488.

Abdullah N R, Mamat R, Wyszynski M L, Tsolakis A, Xu H. Effects of pilot injection timing and EGR on a modern V6 common rail direct injection diesel engine. 2013 IOP Conf. Ser.: Mater. Sci. Eng. 50012008.

Cerda S, Romero J, Navasquillo J, Zurita J. A new time-frequency representation: Analysis of the combustion noise. Acta Acustica United with Acustica, 2001; 87(3): 423–425.

Hou J X, Qiao X Q, Wang Z, Liu W, Huang Z. Characterization of knocking combustion in HCCI DME engine using wavelet packet transform. Applied Energy, 2010; 87(4): 1239–1246.

Bodisco T, Reeves R, Situ R, Brown R. Bayesian models for the determination of resonant frequencies in a DI diesel engine. Mechanical Systems and Signal Processing, 2012; 26(1): 305–314.

Hou J X, Qiao X Q, Wang Z, Liu W. Study on combustion stability of a DI-HCCI engine fueled with dimethyl ether. Journal of the Energy Institute, 2010; 83(2): 63–68.

Amann C A. Cylinder-pressure measurement and its use in engine research. SAE paper 852067.

Heywood J B. Internal combustion engine fundamentals. McGraw-Hill, Inc., 1988.

Randolph A L. Methods of processing cylinder-pressure transducer signals to maximize data accuracy. SAE Paper 900170.

Oh S, Kim J, Oh B, Lee K, Sunwoo M. Real-time IMEP estimation and control using an in-cylinder pressure sensor for a common-rail direct injection diesel engine. J. Eng. Gas Turbines Power, 2011; 133(6): 831–844.

Han D, Ickes A M, Assanis D N, Bohac S V. Attainment and load extension of high-efficiency premixed low temperature combustion with dieseline in a compression ignition engine. Energy Fuels, 2010; 24(6): 3517–3525.

Han D, Ickes A M, Bohac S V, Huang Z, Assanis D N. Premixed low temperature combustion of blends of diesel and gasoline in a high speed compression ignition engine. Proc Combust Inst, 2010; 33(2): 3039–3046.

Schneider M, Schmillen K, Pischinger F. Regularities of cylinder pressure oscillations and their effects on the combustion process and noise. Measurement, 1987; 2013: 2–15.

Hou J, Wen Z, Jiang Z, Liu Y. Effects of premixed ratio on combustion characteristics of a homogeneous charge compression ignition-direct injection engine fueled with dimethyl ether. Journal of Renewable and Sustainable Energy, 2014, 6(1): 104–108.

Maurya R K, Pal D D, Agarwal A K. Digital signal processing of cylinder pressure data for combustion diagnostics of HCCI engine. Mechanical Systems and Signal Processing, 2013; 36(1): 95–109.




Copyright (c)



2023-2026 Copyright IJABE Editing and Publishing Office